66 53 020 Removing and installing/replacing reversing camera RFK (after 10/2009)

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove TAILGATE UPPER SECTION TRIM PANEL .

Unlock holder (1) in direction of arrow.

Remove reversing camera (2).

Replacement

Remove protective film from reversing camera lens.

Fig 1: Removing Reversing Camera Protective Film

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Remove reversing camera (2).

Fig 2: Removing Reversing Camera

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Calibrate REVERSING CAMERA