66 53 010 Calibrating reversing camera (from 10/2009)

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Calibration of reversing camera must be carried out after the following work:

Removal and installation/replacement of reversing camera
Body repair work at rear end of vehicle
Adjusting work at tailgate

IMPORTANT: Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:

Vehicle standing level on headlight aiming station
Correct tire inflation pressure (see label on vehicle).
Vehicle is free of load
Rear seat bench is unoccupied
Do not swap seats during calibration
Steering wheel in straight-ahead position
Do not move steering wheel

NOTE: Also switch on reversing camera by means of PDC button.

Calibration can only be carried out with the BMW diagnosis system.

Use of a special tool is no longer required from 10/2009!

Service functions:

Complete vehicle
Driver assistance
Reversing camera