LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3031 (Body Equipment - Repair) >> Rear Lid Trim Panel >> 51 49 000 Removing and installing/replacing panel for rear lid

51 49 000 Removing and installing/replacing panel for rear lid

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks 

Release screws (1) in recessed handle.

Feed back handle (2) of emergency unlocking.

Release panels (3) at clips (4) and remove.

Fig 1: Identifying Back Handle, Panels, Clips And Screws
G08529436Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace faulty clips (1 and 2).

Make sure all clips are installed in correct position.

  1. Grey clip
  2. White clip
    Fig 2: Identifying Faulty Clips
    G08529437Courtesy of BMW OF NORTH AMERICA, INC.