72 11 033 Removing and installing or replacing front seat belt (Coupe)

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove panel for door post . See 51 43 148 REMOVING AND INSTALLING OR REPLACING PANEL FOR LEFT OR RIGHT DOOR PILLAR .

NOTE: If a seat belt which is damaged due to an accident is exchanged, check the slide bar for damage (bending) and replace if necessary.

Lever out cap (1).

Release screw (2).

Tightening torque, see 72 11 05AZ in 72 11 SEAT BELTS .

Installation:

Check that spacer bushing (3) and rubber ring (4) are in correct position.

Fig 1: Identifying Cap, Screw, Spacer Bushing And Rubber Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque, see 72 11 04AZ in 72 11 SEAT BELTS .

Installation:

Fig 2: Identifying Screws, Deflection Bracket And Deflection Fitting

Courtesy of BMW OF NORTH AMERICA, INC.

Remove deflection bracket (2).

Release screw (3).

Tightening torque, see 72 11 03AZ in 72 11 SEAT BELTS .

Remove belt deflection fitting (4).

Release screw (1).

Tightening torque, see 72 11 01AZ in 72 11 SEAT BELTS .

Remove automatic reel (2).

Installation:

Coding (3) of automatic reel must be seated in body opening.

Fig 3: Identifying Screw, Automatic Reel And Coding

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: Open spaces (A) and (B) from seat belt strap to guide funnel must have the same dimensions.

Fig 4: Identifying Free Spaces From Seat Belt Strap To Guide Funnel

Courtesy of BMW OF NORTH AMERICA, INC.