51 43 148 Removing And Installing Or Replacing Panel For Left Or Right Door Pillar

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Lever out cap (6) and release screw underneath.

Remove coat hook (7).

Release side trim panel (1) at retainers (2) and clip (3).

Release trim panel (5) at clips (4) and remove in downward direction.

Installation:

If necessary, replace faulty clips (3 and 4).

Fig 1: Identifying Coat Hook, Trim Panel & Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Complete removal only:

Lever out cap (1).

Release screw (2) and detach seat belt strap.

Tightening torque, see 72 11 5AZ in 72 11 SEAT BELTS and/or 72 11 SEAT BELTS .

Feed out seat belt strap from trim for door pillar.

Installation:

Check that spacer bushing (3) and rubber ring (4) are in correct position.

Fig 2: Identifying Spacer Bushing & Rubber Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guides (1) on trim (2) must not be damaged.

Fig 3: Identifying Guides On Trim

Courtesy of BMW OF NORTH AMERICA, INC.