51 16 200 Removing And Installing Storage Compartment

Special Tools Required 

• 00 9 317 

Necessary preliminary tasks: 

• Move selector or gear lever towards rear
• Remove trim for gearshift  
• Detach panel for pedal assembly   from storage compartment
• Detach instrument panel trim   at bottom from storage compartment
• Remove trim on storage compartment at rear  
• Remove gaiter for handbrake lever  . See 34 41... REMOVING AND INSTALLING OR REPLACING GAITER FOR HANDBRAKE LEVER (128i) or 34 41... REMOVING AND INSTALLING OR REPLACING GAITER FOR HANDBRAKE LEVER (135i) .

Release screws (1) on storage compartment (2) at front.

Fig 1: Identifying Storage Compartment & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Version with center armrest: 

Lever out cover (1) and release nut (2) underneath.

Fig 2: Identifying Cover & Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Lever socket mounting (1) or trim with special tool 00 9 317  out of storage tray (2).

If necessary, disconnect associated plug connections and remove socket receptacle (1).

Fig 3: Identifying Lever Socket Mounting & Storage Tray

Courtesy of BMW OF NORTH AMERICA, INC.

Version without center armrest: 

Release nut (1) on storage compartment (2).

Fig 4: Identifying Storage Compartment & Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Fig 5: Identifying Nut To Be Slackened

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out cover (1) on storage compartment (2) at side and release screw underneath.

Fig 6: Levering Out Cover & Storage Compartment

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) on storage compartment (2) at rear.

Fig 7: Identifying Storage Compartment & Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten handbrake lever (1) as far as possible.

Raise storage compartment (2) at rear and feed out over handbrake lever (1) and gearshift or preselector lever in upwards direction.

Fig 8: Tightening Handbrake Lever

Courtesy of BMW OF NORTH AMERICA, INC.