52 14 000 Removing and installing left or right front seat (normal/electric)

Necessary preliminary tasks: 

• Remove front head restraint. See HEAD RESTRAINT (NORMAL/ELECTRIC/SEMI-ELECTRIC SEAT)  or CRASH-ACTIVE HEAD RESTRAINTS .
• Remove OUTER COVER  on front seat

Switch off ignition!

Adjust front seat as far forward and upward as possible.

Release screws.

Tightening torque: see 1AZ in 52 10 FRONT SEATS .

Fig 1: Identifying Adjustment Of Front Seat In Forward And Upward Position

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) for belt mounting.

Replace screw for installation. Tightening torque 44 N.m.

Fig 2: Identifying Belt Mounting Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Move front seat as far back as possible.

Raise bridge (1) on front right seat rail cover slightly and unlock.

Pull cover forwards to remove.

Fig 3: Raising Bridge On Front Right Seat Rail Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Press rocker switch (1) on front left seat rail cover and unlock.

Gently slide cover (2) towards front.

Carefully unlock inside edge (3) from inside.

Pull cover forwards to remove.

Fig 4: Pressing Rocker Switch On Front Left Seat Rail Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release front screws on left and right seat rails.

Tightening torque: see 1AZ in 52 10 FRONT SEATS .

Fig 5: Locating Left And Right Seat Rails Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Floor carpet must not project between seat rail and floor board in area of screw-down points (grinding noises).

Carefully tip seat towards rear.

Unclip cover (1) towards front.

Disconnect plug connections (yellow and black) on seat modules.

Lift out front seat.

Fig 6: Unclipping Cover

Courtesy of BMW OF NORTH AMERICA, INC.