33 31 011 Replacing rear axle carrier
WARNING: This page is about a different car, the 2009 BMW 550i and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.
Close off pipe connections with plugs.
Necessary preliminary tasks:
- Remove rear differential .
- Remove complete rear axle carrier and if necessary with other workers assisting set down on a suitable surface.
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from rear axle carrier. See 37 13 110 REMOVING AND INSTALLING/REPLACING PRESSURE LINE FOR OSCILLATING MOTOR/REAR AXLE .
- Remove both stabilizer links from stabilizer .
- Remove stabilizer from rear axle carrier .
- Remove ride-height sensor with holder from rear axle carrier . See 37 14 512 REPLACING REAR RIDE-HEIGHT SENSOR .
Remove swinging arm on both sides from rear axle carrier .
Remove control arm on both sides from rear axle carrier .
Remove guide arm on both sides from rear axle carrier .
Remove wheel carrier on both sides with output shaft, swinging arm and suspension arms.
After installation:
- Version with Dynamic Drive:
- Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT .
- Check pipe connections for leaks
- Adjust handbrake . See 34 10 014 ADJUSTING HANDBRAKE .
- Perform chassis alignment check . See 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION or 32 00 155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .
- If necessary, carry out initial Dynamic Drive operation . See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .