72 12 000 Removing And Installing/Replacing Airbag Module On Passenger Side

WARNING: This page is about a different car, the 2008 BMW 550i, 2007 BMW 550i, and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.

Incorrect handling can activate airbag and cause injury.

Necessary preliminary tasks:

Disconnect battery negative lead
Follow INSTRUCTIONS for unlocking and locking airbag plug connections
Remove GLOVEBOX with housing

Version (E60/E61) with front drinks holder:

Remove front outer cup holder CARRIER
Release front inner cup holder CARRIER
Inner carrier can only be removed together with airbag module.

Unfasten plug connection (1) and disconnect. Remove plug connection from holder (by turning).

IMPORTANT:

Before releasing screws (3), secure airbag module (2) against falling out.

E63/ E64:

Release screws (3) and carefully feed out airbag module (2) towards bottom.

E60:

Release screws (3); if necessary, slide front inner cup holder carrier slightly to one side.

Carefully remove airbag module (2), if necessary with front inner cup holder carrier, towards bottom rear.

Fig 1: Identifying Airbag Module And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

When inserting airbag module (1) in channel (2), make sure channel rests all round airbag module. If necessary, pull channel apart at sides.

Replace screws.

Tightening torque: 72 12 02AZ . See AIRBAG MODULES for specs.

Fig 2: Identifying Airbag Module

Courtesy of BMW OF NORTH AMERICA, INC.