66 54 010 Removing and installing complete night vision camera

WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on Protection Against Electrostatic Damage (ESD Protection).

Necessary preliminary tasks:

Remove Front bumper trim
Remove front underbody protection
Remove air duct for brake ventilation on left sides
Partially remove cooling air duct
Remove air duct (brake)

Unclip tube (1) from guide.

Disconnect associated plug connection.

Unscrew nuts (2).

For tightening torque refer to 66 54 1AZ in 66 54 NIGHT VISION CAMERA .

Fig 1: Tube Guide And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

For tightening torque refer to 66 54 1AZ in 66 54 NIGHT VISION CAMERA .

Disconnect hose connection (2) and remove holder with night vision camera (3).

Fig 2: Hose Connection, Screws And Night Vision Camera

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill up with washer fluid

Replacement only: