51 11 156 Removing and Installing Front Bumper Trim

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both protective strips See 51 11 170 REPLACING BODY MOLDING FOR LEFT OR RIGHT BUMPER
Remove baseplate for number/license plate. See 51 11 158 REPLACING BASEPLATE FOR LICENSE PLATE

Build date up to 03/2005:

Remove both fog lamps See 63 17 060 REMOVING AND INSTALLING (REPLACING) LEFT OR RIGHT FRONT FOG LAMP

Build date from 03/2005:

Remove both side grilles See 51 11 185 REMOVING AND INSTALLING/REPLACING SIDE TRIM GRILLE FOR BUMPER TRIM (FROM 03/2005)

Release screws (1) or clip (1) on left/right.

Fig 1: Identifying Screws Or Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

IMPORTANT: Bumper trim must not be pulled out sideways (risk of damage).

Remove bumper trim straight towards front with aid of a 2nd person.

If necessary, disconnect additional plug-in contacts and feed out cable.

Installation:

Observe gap dimensions . See BODY GAP DIMENSIONS .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.