51 47 490 Removing and Installing/Replacing Front Underbody Protection

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Except BMW ALPINA B7:

Release expansion rivet (1).

Release screws (2) and then catches in area (A).

Remove underbody protection (3) towards rear.

Installation:

Ensure correct seating.

Center underbody protection (3) and secure.

Fig 1: Identifying Center Underbody Protection And Expansion Rivet

Courtesy of BMW OF NORTH AMERICA, INC.

Version with bad weather package:

Release screws (1).

Release screws (2) and remove underbody protection (3) downwards

Installation:

Replace screws (2).

Tightening torque 31 10 9AZ. See 31 10 FRONT AXLE SUSPENSION

Fig 2: Identifying Screws & Remove Underbody Protection

Courtesy of BMW OF NORTH AMERICA, INC.

BMW ALPINA B7:

Release screws (1) and remove holder (2).

Release retaining elements (3) and remove underbody protection (4).

Fig 3: Identifying Retaining Elements, Holder & Underbody Protection

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing - except BMW ALPINA B7:

Release screws (1).

Release catches (2) and remove lip (3).

Fig 4: Identifying Catches & Lip

Courtesy of BMW OF NORTH AMERICA, INC.