66 54 511 Replacing Night Vision Camera
WARNING: This page is about a different car, the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, and 2007 BMW 750Li. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection).
See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
IMPORTANT:
New component contains a CD with deblocking code.
Deblocking code CD is requested during coding/programming by the SSS.
Coding/programming without the deblocking code CD is not possible!
Necessary preliminary tasks:
- Remove night vision camera See 66 54 010 REMOVING AND INSTALLING COMPLETE NIGHT VISION CAMERA
Release screw (1) on both sides.
Remove camera (2) from holder (3).
Installation:
Insert camera (1) in holder (2).
Left guide pin (3) must be correctly seated in holder (2).
Apply screw securing adhesive to screw (4) and tighten screw.
Tab (1) must snap noticeably into holder (2).
Make sure guide pin (3) is correctly seated in holder.
Apply screw securing adhesive to screw (4) and tighten screw.
Installation:
- Using BMW scan tool, carry out coding/programming.
- Adjust night vision camera See 66 54 001 ADJUSTING NIGHT VISION CAMERA