12 42 500 Removing And Installing Or Replacing Battery Positive Lead (Between Alternator, Starter And Battery Positive Terminal) (N62)
REFERENCE CHART (N62)
| Work step | Note: |
|---|---|
| Switch off ignition | |
| Disconnect battery negative lead | Follow instructions for disconnecting and connecting battery |
| Disconnect battery positive lead at jump start connection point | Tightening torque: 12 42 1AZ . See WIRES TO STARTER for specs. |
| REMOVE SUCTION FILTER HOUSING . | |
| REMOVE RIGHT FRESH AIR DUCT . | |
| Remove centre equipment compartment heater bulkhead. | |
| Remove INTAKE AIR MANIFOLD | |
| REMOVE A/C COMPRESSOR DRIVE BELT . | |
| Detach battery positive lead from alternator | Tightening torque: 12 31 1AZ . See ALTERNATOR WITH DRIVE AND MOUNTING PARTS for specs. |
| LIFT ENGINE HOOD INTO ASSEMBLY POSITION . | |
| SECURE ENGINE IN INSTALLATION POSITION WITH SPECIAL TOOL | |
| Release grounding strap on engine support arm. | |
| RELEASE A/C COMPRESSOR AND PLACE TO ONE SIDE . | |
| Remove EXHAUST SYSTEM | |
| Remove right exhaust manifold | |
| Lower front axle | |
| Remove STARTER MOTOR . | Tightening torque: 12 41 4AZ . See STARTER AND MOUNTING PARTS for specs. |
| Detach battery positive lead from support point/terminal | Tightening torque: 12 42 1AZ . See WIRES TO STARTER for specs. |
Unclip battery positive lead (2) from holders (1).
Installation:
Make sure battery positive lead is in correct installation position.
Danger of short circuits.
Add final details to vehicle.
Check function of DME.