11 61 050 Removing And Installing Intake Air Manifold (N62)

Remove design cover.

Remove center of bulkhead.

Remove intake hose.

On rear side of manifold, unlock and disconnect plug on differential pressure sensor and on servomotor.

Unlock and detach vent hose (1).

Remove cable from holder.

Fig 1: Identifying Vent Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Remove intake air manifold (2) upwards with aid of a second person.

Fig 2: Identifying Intake Air Manifold

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean sealing faces (1) on intake air manifold (2).

Fig 3: Identifying Sealing Faces On Intake Air Manifold

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean sealing face (1) on left and right.

Replace gasket on left and right.

Fig 4: Identifying Sealing Face On Left And Right

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check air intake system for leaks.