61 71 061 Replacing Fluid Reservoir For Windshield Washer System

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Unclip wiring harness fasteners (1) in direction of arrow out of fluid reservoir for windshield washer unit (2).

Release screw (3).

NOTE: Catch any escaping washer fluid if necessary.

Unlock filler hose (4) and detach from fitting on fluid reservoir (5).

Fig 1: Identifying Unlock Filler Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Pull fluid reservoir for windshield washer system (2) in direction of arrow out of holder.

Disconnect all plug connections (1).

Disengage hose for washer pump (3) from fluid reservoir for windshield washer system (2).

Remove window washer pump
Remove level switch
If necessary, remove washer pump for headlight cleaning system
If necessary, remove washer pump for rear window washer system

Fig 2: Pulling Fluid Reservoir For Windshield Washer System
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure lug (2) of water reservoir for windshield washer unit (1) fits correctly in retaining fixture (3).

Fig 3: Identifying Retaining Fixture & Lug

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip auxiliary direction indicator wiring harness (1) in direction of arrow out of fluid reservoir for windshield washer unit (2).

Installation:

Make sure auxiliary direction indicator wiring harness (1) is laid correctly.

Remove fluid reservoir for windshield washer system (2) in direction of arrow.

Fig 4: Identifying Windshield Washer System

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace strainers on washer pumps
Coat sealing rings of washer pumps with anti-seize agent
Lay hoses of washer pumps without kinks and clip into holders on fluid reservoir
Fill fluid reservoir