51 11 050 Removing And Installing / Replacing Carrier For Front Bumper Trim

Necessary preliminary tasks:

Build date from 03/2005:

Not build date from 03/2005:

Release screw (1).

Remove upper air duct section (2) on left/right.

Fig 1: Identifying Upper Air Duct Section

Courtesy of BMW OF NORTH AMERICA, INC.

Remove impact absorber (2) towards front.

Release screws (1) and remove bracket/rod.

Disconnect plug connection on fanfare horn on left/right

If necessary, disconnect plug connection on ACC sensor and night vision camera.

Replacement:

Release screw (3) on left/right and remove fanfare horn.

Fig 2: Identifying Impact Absorber

Courtesy of BMW OF NORTH AMERICA, INC.

Release catches (1).

Remove cover (2) on left/right.

Fig 3: Identifying Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Version with headlight washer system:

Detach water hose (1) from high-pressure nozzle on right and seal off with rubber plug.

Feed water hose (1) out of carrier.

Fig 4: Identifying Water Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Version with night vision:

Detach water hose (2) from night vision camera and seal off with rubber plug.

Feed out water hose (2).

Fig 5: Identifying Water Hose

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, detach HIGH-PRESSURE NOZZLE OF HEADLIGHT WASHER SYSTEM from carrier and unclip wiring harness (1) from carrier.

Fig 6: Identifying Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 and 2) on left/right.

Remove carrier towards front.

Tightening torque: 51 11 4AZ . See FRONT BUMPER for specs.

Fig 7: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement (depending on Security version):