51 11 156 Removing And Installing/Replacing Front Bumper Trim (BMW ALPINA B7)

Necessary preliminary tasks:

Remove cover (1) and air duct (2) on left/right.

Fig 1: Identifying Cover And Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on left/right.

Release screws (2) on bracket (3) on left/right.

Fig 2: Identifying Bracket And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) or clip (1) on left/right.

Fig 3: Identifying Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

IMPORTANT:

Bumper trim must not be pulled out sideways (risk of damage).

Feed out cable for ultrasonic transducer and, with a 2nd person helping, remove bumper trim (2) towards front.

Installation:

Observe gap dimensions.

Fig 4: Identifying Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.