33 55 000 Removing and installing / replacing rear stabilizer
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove both Rear Coil Springs
- Remove Left Control Arm On Wheel Carrier
- Remove Stabilizer Link From Wheel Carrier
- Lower Rear Axle Carrier
NOTE:
To simplify the illustration, removal of the stabilizer is depicted on the removed rear axle.
Turn stabilizer (2) and remove sideways.
Release screws (1).
Remove Rubber Mount On Both Sides From Stabilizer.
Turn stabilizer (2) and remove sideways.
Installation:
Check Rubber Mount On Both Sides For Damage , replace if necessary.
For tightening torque refer to 33 55 1AZ in 33 55 STABILIZER BAR .
After installation:
- Bleed Braking System