33 21 002 Removing and installing / replacing right output shaft

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Expand turning lock sufficiently to avoid damaging thread when releasing collar nut.

Release collar nut (1), activate handbrake for this purpose.

Installation:

Replace collar nut, apply a light coating of oil to contact surface and tighten down.

No oil permitted on thread of shaft journal or collar nut.

For tightening torque refer to 33 41 1AZ in 33 41 WHEEL BEARINGS .

Secure collar nut by peening on flat areas of output shaft.

Fig 1: Identifying Output Shaft Collar Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Remove tension strut if necessary

Release bolts and remove with washers (1).

Press output shaft off drive flange using a suitable tool; if necessary, raise wheel carrier with workshop jack approx. 20 mm.

Installation:

Before installing output shaft, make sure that drive flange is fully engaged in rear differential.

Replace bolts and washers (1).

For tightening torque refer to 33 21 1AZ in 33 41 WHEEL BEARINGS .

Fig 2: Identifying Output Shaft Mounting Bolts And Washers

Courtesy of BMW OF NORTH AMERICA, INC.

Press output shaft out of drive flange and remove towards centre of vehicle.

After installation: