34 52 550 Removing and installing / replacing DSC sensor
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection).
Necessary preliminary tasks:
- Remove Left Front Seat
- Remove Front Left Entrance Cover Strip
Lift carpet (1) and fold back to side.
Remove underlay (2).
Disconnect plug connection.
Installation:
Ensure proper locking of plug connector.
Slacken screws (3)
Release screws (4) and remove bracket with yaw sensor.
Installation:
For tightening torque refer to 34 51 3AZ in 34 51 SLIP CONTROL SYSTEM (DSC) .
When replacing DSC sensor:
Release screws (1) and modify DSC sensor (2).
Installation:
For tightening torque refer to 34 51 2AZ in 34 51 SLIP CONTROL SYSTEM (DSC) .