52 13 000 Removing and installing left or right front seat (normal / manual)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

WARNING: Read and comply with Safety Regulations for handling airbag modules and pyrotechnical belt tensioners.

Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Switch off ignition.

Lever out trim (1) for belt anchor fitting with plastic wedge.

Fig 1: Identifying Belt Anchor Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque value 44Nm.

Remove anchor fitting (2).

Installation:

Make sure anchor fitting (2) is correctly seated on seat mechanism pin.

Fig 2: Identifying Belt Anchor Fitting And Mounting Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation:

Replace screws.

For tightening torque refer to 52 10 1AZ in 52 10 FRONT SEATS .

Move front seat as far back as possible.

Fig 3: Identifying Front Seat Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (3).

Installation:

Replace screws.

For tightening torque refer to 52 10 1AZ in 52 10 FRONT SEATS .

Unlock plug connection (1) and disconnect plug (2).

IMPORTANT: Cover door sill with protective covers (risk of damage).

Lift out front seat.

Fig 4: Identifying Plug Connection, Retaining Screws And Plug Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carpet must not get between seat rails and floor pan in area of fastening points (grating noises).