52 26 199 Removing and installing/replacing rear panel on left rear seat backrest

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Lever backrest cover all round out of backrest frame.

Fig 1: Identifying Rear Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Detach rear panel (2) with flat scraper (1) from rear seat backrest.

Installation:

Comply with instructions issued by manufacturer of universal spray adhesive.

Apply universal spray adhesive to rear panel and rear seat backrest.

Fit and align rear panel within the air drying time (see manufacturer's instructions).

Observe and adhere to curing time to prevent rear panels from slipping.

Fig 2: Identifying Back Seat Rear Panel And Flat Scraper

Courtesy of BMW OF NORTH AMERICA, INC.