52 26 020 Removing and installing/replacing both backrests for rear seat
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove Armrest Side Section
- Remove Rear Seat
NOTE:
A 2nd person is required to help remove and install the backrest.
Left backrest:
- Release screw (1).
For tightening torque refer to 52 26 01AZ in 52 24 REAR SEAT (NORMAL), MANUAL .
- Lay belt (2) around centre armrest
- Fold backrest forwards slightly (3)
- Pull backrest forwards and outwards out of centre mount (4)
Right backrest:
- Release screw (1).
For tightening torque refer to 52 26 01AZ in 52 24 REAR SEAT (NORMAL), MANUAL .
- Fold backrest forwards slightly (2)
- Pull backrest forwards and outwards out of centre mount (3)