52 26 ... Removing and installing/replacing ski bag with casing on rear seat (through-loading system)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Press ski bag (1) on rear side out of backrest.

Fig 1: Identifying Ski Bag

Courtesy of BMW OF NORTH AMERICA, INC.

Lift off cover (1).

Release screws (2).

Installation:

Make sure cover is correctly installed.

Fig 2: Identifying Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip single opening trim (1) towards top.

Installation:

Plastic clips must not be damaged

If necessary, replace faulty trim.

Remove C-module trim (1) in direction of arrow.