Overview - Assembly Mounts

Fig 1: Exploded View Of Assembly Mounts

Courtesy of AUDI OF AMERICA, LLC

1. 1 -

   Bolt

   • 40 Nm +90°
   • Replace after removing
2. 2 -

   Engine Mount

   • With support arm
   • Adjustment, checking. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .
   • Adjusting. Refer to ASSEMBLY MOUNT, ADJUSTING .
   • Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
3. 3 -

   Bolt

   • 40 Nm +90°
   • Replace after removing
4. 4 -

   Bolt

   • 40 Nm +90°
   • Replace after removing
5. 5 -

   Bolt

   • 20 Nm +90°
   • Replace after removing
6. 6 -

   Bolt

   • 40 Nm +90°
   • Replace after removing
7. 7 -

   Bolt

   • Tightening specification and sequence. Refer to Fig 2.
8. 8 -

   Pendulum Support

   • Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
9. 9 -

   Bolt

   • Tightening specification and sequence. Refer to Fig 2.
10. 10 -

    Bolt

    • Tightening specification and sequence. Refer to Fig 2.
11. 11 -

    Bolt to Transmission

    • 60 Nm +90°
    • Replace after removing
12. 12 -

    Bolt to Longitudinal Member

    • 50 Nm + 90°
    • Replace after removing
13. 13 -

    Transmission Mount

    • Adjustment, checking. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .
    • Adjusting. Refer to ASSEMBLY MOUNT, ADJUSTING .
    • Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .

Pendulum Support - Tightening Specifications and Sequence

Fig 2: Engine Support Component Location

Courtesy of AUDI OF AMERICA, LLC

• Replace bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps in the sequence shown: