Assembly Mount, Adjusting

WARNING: This page is about a different car, the 2024 Audi RS 3. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Free up the wiring harness on the bracket -1- for the air filter housing.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the bracket for the air filter housing (example illustration above).

-- Remove the bolts -arrows- for the transmission mount -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Replace all three bolts one after another and install them by until they are in position.

-- Make sure that the edges on the support arm -1- and transmission mount -2- are parallel on the transmission side.

Fig 1: Edges On Support Arm And Transmission Mount Are Parallel

Courtesy of AUDI OF AMERICA, LLC

Dimension -x- = dimension -x-.

-- Tighten the transmission mount bolts.

-- Check the installation position at the engine mount:

Fig 2: Checking Installed Position On Engine Mount

Courtesy of AUDI OF AMERICA, LLC

The support arm must be a distance of at least -a- = 9 mm to the engine mount.

TIP:

The dimension -a- can be checked using a 9 mm drill bit, for example.

-- If required, slide the engine/transmission assembly to the side.

Assemble in the reverse order of removal. Note the following:

-- Remove the Engine Support Bridge :10-222A from the engine. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

Tightening Specifications