Bumper Carrier Mount, Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the connector -1- on the horn -2- and free up the wiring harness -3-.
-- Remove the bolts -arrows-.
-- Remove the bolts -1 and 4-.
-- Pull the lock carrier -3- slightly forward, push the bumper carrier mount -2- upward and out of the guide -5- -arrow- and remove it to the side.
Installing
Install in the reverse order of removal while noting the following:
-- Adjust the spring element. Refer to HEIGHT, ADJUSTING USING SPRING ELEMENT .
Tightening Specifications
- Refer to OVERVIEW - BUMPER CARRIER
- Refer to OVERVIEW - LOCK CARRIER