Overview - Bumper Carrier

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Bumper Carrier

Courtesy of AUDI OF AMERICA, LLC

Molded Foam Part
- Depending on the version
- Removing and Installing. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
Bracket
- For the Outside Air Temperature Sensor -G17-
Bolt
- Depending on the version
- 2.5 Nm
Outside Air Temperature Sensor -G17-
- Removing and Installing. Refer to Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING .
Bumper Carrier
- Removing and Installing. Refer to BUMPER CARRIER, REMOVING AND INSTALLING .
Bolt
- Quantity: 4
- 55 Nm
Lock Carrier
Bolt
- Quantity: 2
- Tightening specification Refer to Fig 2.
Bolt
- For securing the bumper carrier to the lock carrier
- Quantity: 2
- 14 Nm
Nut
- Tightening specification. Refer to OVERVIEW - HORN .
Bracket with Horn
- Removing and Installing. Refer to HIGH TONE HORN -H2- /LOW TONE HORN -H7-, REMOVING AND INSTALLING .
Bumper Carrier Mount
- Removing and Installing. Refer to BUMPER CARRIER, REMOVING AND INSTALLING .
Connecting Brace
- Market-Specific Version
Bolt
- Quantity: 2
- 9 Nm
Nut
- Quantity: 2
Driver Side Pedestrian Protection Crash Sensor 2 -G851- /Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
- Unit with pressure hose
- Must be replaced when
  - Molded foam part visibly damaged
  - Bumper carrier visibly damaged
  - The bumper cover is deformed.
  - The pressure hose is damaged.
- Removing and Installing. Refer to OVERVIEW - PEDESTRIAN PROTECTION .

Front bumper carrier - tightening specification and sequence

Fig 2: Front Impact Member

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -A- to 23 Nm in the following sequence: -1 through 4-.