Overview - Electric Drive Control Module On Rear Axle J1235/J1236, S Model
- Electric Drive Control Module on Rear Axle -J1236-
- Installation position in direction of travel on the left side
- Refer to ELECTRIC DRIVE CONTROL MODULE ON REAR AXLE J1235/J1236, REMOVING AND INSTALLING, S MODEL
- Sealing Element
- Replace after removing
- Electric Drive Control Module on Rear Axle -J1235-
- Installation position in direction of travel on the right side
- Refer to ELECTRIC DRIVE CONTROL MODULE ON REAR AXLE J1235/J1236, REMOVING AND INSTALLING, S MODEL
- Bolt
- Replace after removing
- Refer to Fig 1
- Alignment Pin
- Quantity: 2
- O-Ring
- Replace after removing
- Coolant Connection
- Replace after removing
- O-Ring
- Replace after removing
- O-Ring
- Replace after removing
- Coolant Connection
- Replace after removing
- O-Ring
- Replace after removing
- Bolt
- For high-voltage cable
- 15 Nm
- Rear Axle Electric Drive Motor -V663-
- Installation position in direction of travel on the right side
- Refer to Rear Motors, Removing .
- Refer to Rear Motor, Installing .
- Noise Insulation
- Clip
- Quantity: 12
- Replace after removing
- Bolt
- Torx bolt T25 (quantity: 3)
- Torx bolt T30 with security pin and thread-locking fluid (quantity: 3)
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Cap
- For high-voltage cables
- Replace after removing
- Bolt
- For high-voltage cable
- 15 Nm
- Rear Axle Electric Drive Motor 2 -V648-
- Installation position in direction of travel on the left side
- Refer to Rear Motors, Removing .
- Refer to Rear Motor, Installing .
- Cap
- Replace after removing
- Bolt
- Torx bolt T25 (quantity: 3)
- Torx bolt T30 with security pin and thread-locking fluid (quantity: 3)
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- O-Ring
- Replace after removing
- Coolant Connection
- Replace after removing
- O-Ring
- Replace after removing
- Sealing Element
- Replace after removing
- O-Ring
- Replace after removing
- Coolant Connection
- Replace after removing
- O-Ring
- Replace after removing
- Alignment Pin
- Quantity: 2
- Bolt
- Replace after removing
- Refer to Fig 1
Electric Drive Control Module on Rear Axle J1235/J1236 - Tightening Specification and Sequence
Fig 1: Electric Drive Control Module on Rear Axle J1235/J1236 - Tightening Specification and Sequence
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1- through -4- | 20 Nm |
| 2. | -1- through -4- | 45° additional turn |
Bolts for High-Voltage Cable Cover - Tightening Specification and Sequence
| Sequence | Bolts | Tightening Specification |
|---|---|---|
| 1. | Torx bolt T25 -4- and -6- | 15 Nm |
| 2. | Torx bolt T25 -2- | 15 Nm |
| 3. | Torx bolt T30 with safety pin and thread-locking fluid -1-, -3- and -5- | 15 Nm |