Rear Motor, Installing
Installing
Install in reverse order of removal and note the following:
Condition
- If the drive motor is being replaced, install new pressure equalization elements.
- If the drive motor is being replaced, install new centering pins.
- Always replace a removed clip for noise insulation on the motor.
-- After installing the high-voltage components or potential equalization cables a potential equalization measurement must be performed on the corresponding high-voltage components. Refer to Potential Equalization Measurement .
-- Refer to FILLING AND BLEEDING THE COOLANT .
High voltage increases the risk of fatal injury
Electrocution can cause severe bodily or fatal injury.
- Have a high-voltage technician or an high-voltage expert bring the high-voltage system back into service.
-- Refer to High-Voltage System, Re-Energizing .
Condition
- If the Electric Drive Control Module on Rear Axle -J1235- or the Electric Drive Control Module 2 on Rear Axle -J1236- is replaced, select the "Control module, replacing" function on the control module using the Vehicle Diagnostic Tester.
If the motor/motors was/were replaced, perform the test plan for replacing the control module.
-- Perform the Electric Drive Control Module on Rear Axle -J1235- /Electric Drive Control Module 2 on Rear Axle -J1236- replacing function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries
Continuation
Tightening Specifications
- Refer to OVERVIEW - ELECTRIC DRIVE CONTROL MODULE ON REAR AXLE J1235, BASE MODEL
- Refer to COMPONENT LOCATION OVERVIEW - HIGH-VOLTAGE CABLES, ELECTRIC DRIVE CONTROL MODULE ON REAR AXLE, BASE MODEL
- Refer to Overview - Rear Assembly Mounts .
- Refer to OVERVIEW - DRIVE AXLE
- Refer to OVERVIEW - UNDERBODY TRIM PANELS .