HYDRAULIC CONTROL UNIT, REMOVING AND INSTALLING, 0D3 "quattro sport" AND 0BX "quattro sport": Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hydraulic Control Unit Tightening Sequence And Components

Courtesy of AUDI OF AMERICA, LLC

Replace the seal between the hydraulic control unit -1- and the final drive housing.
The centering pins -item : Hydraulic Control Unit Housing must be installed inside the housing for the hydraulic control unit.
The left -6- and right -7- lines must be installed loosely when attaching the hydraulic control unit -1-.
The bolt -2- must be installed with a seal.

Attach the hydraulic control unit to the rear final drive as follows:

First install the lines -6- and -7- into the chambers hand-tight -arrows B-.

Then install the bolts -3 to 5- hand-tight.

Coat the threads of the bolt -2- with Sealing Compound: D 176 501 A1 .

Install the bolt -2- with a seal.

Tighten the M8 x 30 screws -2 through 5- to the tightening specification in the sequence: -4-, -2-, -5- and -3-.

Tighten the nuts -A arrows- and -B arrows- on the left -6- and right -7- lines to the tightening specification.

-- Install the All-Wheel Drive Pump -V415-. Refer to Installing .

Fig 2: Identifying Rear Final Drive Wiring Harness Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Install the wiring harness -3- to the final drive and subframe -items 5 through 7-.

-- Connect the connectors -4- and -2-. Pay attention to the marks made during the removal, that identify the allocation to the Oil Pressure/Temperature Sensor -- and which connectors go to the Clutch Valves --.

-- If equipped, position the wiring harness bracket -1- on the rear final drive and tighten the bolts -arrows- to the tightening specification. Make sure the wiring harness -3- does not get pinched.

Allocation of the connectors for the Oil Pressure/Temperature Sensor -- and Clutch Valves -- :

Fig 3: Identifying Oil Pressure/Temperature Sensor Connectors

Courtesy of AUDI OF AMERICA, LLC

-1- = Oil Pressure/Temperature Sensor 2 -G640- Connector
-2- = Oil Pressure/Temperature Sensor -G437- Connector
-3- = All-Wheel Drive Clutch Valve 2 -N446- Connector
-4- = All-Wheel Drive Clutch Valve -N445- Connector

-- Fill the rear final drive with gear oil and then check the level. Refer to GEAR OIL LEVEL, CHECKING, 0D3 "quattro sport" AND 0BX "quattro sport" .

-- Fill the ATF in the rear final drive and check the ATF level. Refer to ATF LEVEL, CHECKING .

-- Install the rear section of the exhaust system and align it so it is free of tension. Refer to the appropriate Exhaust Information .