All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING, 0D3 AND 0BX: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump. Refer to Figure.
- The adapter -B- is installed in the recesses in the hydraulic pump.
- A new O-ring -D- is on the All-Wheel Drive Pump -V415-.
-- Insert the All-Wheel Drive Pump -V415- with the coupling -C- into the adapter -B-.
-- Diagonally tighten the four bolts on the All-Wheel Drive Pump -V415- -2- to the tightening specification -item : Bolt.
-- Connect the connector -1- to the All-Wheel Drive Pump -V415-.
-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0D3 AND 0BX "quattro sport" .