GEAR OIL LEVEL, CHECKING, 0D3 "quattro sport" AND 0BX "quattro sport"
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Test requirement
- Gear oil temperature: 10 °C to 60 °C (50 °F to 140 °F)
- The rear final drive must be in the installed position.
- The vehicle must be level.
- Refer to COMPONENT LOCATION OVERVIEW - DRAIN AND CHECK PLUGS, 0D3 "quattro sport" AND 0BX "quattro sport"
Special tools and workshop equipment required
- Drip Tray
-- Remove the gear oil check plug -1-, located on the right side of the final drive.
- The oil level is correct when the rear final drive is filled up to the lower edge of the oil fill hole.
- Refer to the Parts Information for the correct transmission fluid specification.
-- If necessary, fill the gear oil.
- Refer to GEAR OIL, DRAINING AND FILLING
-- Install and tighten the gear oil check plug -1-. Tightening specification -item : Gear Oil Check Plug.