Fuel Filler Door Unit, Removing And Installing
- The following components must be replaced after removal. Refer to OVERVIEW - FUEL FILLER DOOR UNIT .
Removing
-- Open the cover of the luggage compartment side trim panel and free up the emergency release cable.
-- Loosen the rear section of the right wheel housing liner and push it to the side. Refer to OVERVIEW - REAR WHEEL HOUSING LINER .
-- Free up the drain hose -1- -arrows-.
-- Remove the fuel filler door trim. Refer to FUEL FILLER DOOR TRIM, REMOVING AND INSTALLING .
-- Release the fuel filler door unit by using a small screwdriver to pierce the markings -arrows-.
-- At the top of the fuel filler door unit, pierce a small screwdriver through the markings -arrows- at an angle from below into the fuel filler door through the retainers.
-- Gently lift the screwdriver upward and release the retainers.
-- On the underside, pierce the screwdriver at the markings at an angle from above to below.
-- Gently push the screwdriver downward and release the retainers.
-- Remove the fuel filler door unit with the drain hose gradually from the opening.
-- Disconnect the connector.
-- Remove the fuel filler door unit while guiding out the emergency release cable.
Installing
Install in reverse order of removal and note the following:
-- Insert the hinge side of the fuel filler door unit first into the fuel filler door opening and push it in until it clicks into place.