Rear Glass Panel, Removing And Installing, Q3: Installing

Install in the reverse order of removal while noting the following:

-- Remove any locking fluid residue from the threaded holes using a thread tap.

• When inserting and sliding into the roof opening, the rain water drain channel -1- must be slid under the seal -2- using the Wedge Set - 1: T10383/1 

  Courtesy of AUDI OF AMERICA, LLC

-- Install the rear glass panel bolts, but do not tighten.

-- Adjust the rear glass panel (refer to GLASS PANEL, ADJUSTING, Q3 ), then tighten the bolts.

-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .