All Wheel Drive Clutch, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi Q5 e, and 2021 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Tightening specifications. Refer to OVERVIEW - ALL WHEEL DRIVE CLUTCH
- Check the O-ring -1- on the all-wheel drive clutch input shaft -2- for damage and if necessary replace.
- Apply a thin layer of Sealing Grease -G 052 128 A1- on the splines of the all-wheel drive clutch input shaft.
- Place the all-wheel drive clutch -1- on the transmission and tighten the bolts -arrows- hand-tight.
- Tighten the bolts -arrows- diagonally to the tightening specification.
- Connect the connector -3- to the All-Wheel Drive Control Module -4-.
- Secure the cable to the all-wheel drive clutch -arrow-.
- If equipped, secure the heat shield -2- with the bolts -1-.
- Lift the transmission slightly using the Engine and Gearbox Jack -VAS 6931 -.
- Tighten the tunnel crossmember bolts -arrows-. Tightening Specification. Refer to the appropriate Service Information.
- Check the ATF fluid level of the all-wheel drive clutch. Refer to OIL LEVEL, CHECKING .
- Install the drive shaft. Refer to the appropriate Service Information.
- If equipped, install driveshaft heat shield -1-.
- Install the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
If the clutch was replaced:
- If the all-wheel drive clutch was replaced, it must be activated under. Refer to ADDITIONAL WORK WHEN REPLACING ALL-WHEEL DRIVE CLUTCH .