Oil Level, Checking

Test Requirement:

• The vehicle is in a level position.

Vehicles with vibration damper:

-- Remove the bolts -B arrows- and the heat shield -2- .

-- Remove the bolts -A arrows- and push the vibration damper -1- rearward over the driveshaft.

All Vehicles:

• So that the ATF oil level is set in the all-wheel drive clutch, the ATF drain plug -2- must be unscrewed approximately five turns -a- .

-- Unscrew the ATF drain plug -2- five turns.

• Dimension -a- is approximately 5 mm or five turns.

-- Remove the ATF fill plug -1- .

• The ATF level is correct when the all-wheel drive clutch is filled up to the lower edge of the oil fill hole.
• If necessary, fill ATF up to the lower edge of the oil filler hole.

-- Tighten the ATF fill plug -1- and the ATF drain plug -2- .

Fig 1: Exploded View Of Component Drain And Check Plugs

Tightening Specifications

• Refer to COMPONENT LOCATION OVERVIEW - DRAIN AND CHECK PLUGS 
• Refer to OVERVIEW - ALL WHEEL DRIVE CLUTCH 

Vehicles with vibration damper:

-- Tighten the vibration damper -1- with bolts -A arrows- .

-- Tighten the heat shield -2- with bolts -B arrows- .