Steering Column, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Bring the steering column into the installation position by engaging the mounting hooks -1- on the central tube -2- in direction of -arrow-.
Equipment Versions with Anti-Theft Protection Component:
-- Bring the bolt -2- with the anti-theft protection component lower section -1- into the installation position.
-- Tighten the bolts. Refer to Figure.
-- Drive the anti-theft protection component upper section -3- flush into the lower section using a plastic mallet.
Continuation for All Vehicles:
-- Install the steering intermediate shaft. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .
- Readapting the end position of the steering gear. Refer to STEERING GEAR END POSITIONS, ADAPTING .
- Calibrate the Steering Angle Sensor -G85-. Refer to Steering Angle Sensor -G85- BASIC SETTING .