Steering Angle Sensor -G85- BASIC SETTING
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Steering Wheel Scales:VAS 6458A
Procedure
Select this basic setting for the following operations:
- Settings to the suspension were changed.
- The Steering Column Electronics Control Module -J527- was replaced.
- The Active Steering Control Module -J792- was replaced.
- The steering column was replaced.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Electrical Equipment
- 0001 - OBD-capable systems
- 0016 - Steering Column Electronics Control Module J527
- 0016 - Steering column electronics control module functions
- 0016 - Steering Angle Sensor G85
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- On vehicles with dynamic steering: perform a dynamic steering basic setting. Refer to DYNAMIC STEERING BASIC SETTING .