Overview - Wheel Bearing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Wheel Bearing Housing
- Removing and installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
- Bolt
- Always replace after removing
- 80 Nm + 90°
- Drive Axle
- Wheel Bearing
- Wheel Bearing Unit, Removing and Installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Handling. Refer to Removing
- Wheel Hub
- The lateral run-out on the outer diameter of the wheel hub when installed can be a maximum of 0.02 mm.
- Measure the lateral run-out with the Dial Indicator - 0-10mm:VAS 6079 and Dial Indicator Bracket:VAS 6079/1
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Bolt
- Always replace after removing
- Before installing, clean the threads in the CV joint with a thread tap.
- Drive Axle Threaded Connection, Loosening and Tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .