Drive Axle Threaded Connection, Loosening And Tightening
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Loosen the threaded connection between the drive axle and wheel hub
-- With vehicle still resting on its wheels, loosen the bolt -arrow- a maximum of 90° using the 19 mm inner hex socket, otherwise the wheel bearing will be damaged.
-- Lift the vehicle just enough so that the wheels are hanging free.
-- Press the brake pedal (a second person is needed).
-- Remove the bolt.
Tighten the threaded connection between the drive axle and wheel hub
- Replace bolt after removal.
- Before installing, clean the threads in the CV joint/stub axle with a thread tap.
- Wheels must not yet touch the ground when tightening the drive axle/stub shaft or the wheel bearing can be damaged.
-- Press the brake pedal (a second person is needed).
-- Tighten the bolt to 200 Nm.
-- Set the vehicle on its wheels.
-- Tighten the bolt an additional 180°.