Engine, Supporting In Installation Position

WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Support Bridge:10-222 A

Fig 1: Engine Support Bridge 10-222A
Courtesy of AUDI OF AMERICA, LLC
Engine Support Bridge - Additional Hooks (2 pc.):10-222A/2

Fig 2: Engine Support Bridge Hooks 10-222 A /2
Courtesy of AUDI OF AMERICA, LLC
Adapter:10-222A/31-3

Courtesy of AUDI OF AMERICA, LLC
Engine Support Bridge - Adapter:10-222A/34

Courtesy of AUDI OF AMERICA, LLC
Engine Support Supplement Set:T40093C

Fig 3: Engine Support - Supplement Kit T40093A
Courtesy of AUDI OF AMERICA, LLC

Procedure

Transmission and tunnel crossmember removed.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the left and right front cover for the fender. Refer to OVERVIEW - FENDER .

-- Remove the reinforcement brace. Refer to OVERVIEW - LOCK CARRIER .

CAUTION:

Risk of injury due to the engine weight shifting.

The possibility for parts of the body to be pinched or crushed increases.

- Only support the engine when the transmission and tunnel crossmember are removed.

-- Position the engine support as follows on the left and right on the longitudinal member.

Courtesy of AUDI OF AMERICA, LLC

Engine Support Bridge - Engine Bracket:10-222A/1A
Engine Support Bridge - Engine Support 4:10-222A/4
Engine Support - Joint Fixture:T40091/3
Engine Support Bridge - Spindle:10-222A/11
Adapter:T40093/6A
Engine Support - Basic Set- Pipe:T40091/1
Engine Support Bridge - Spindle:10-222A/11
Adapter:10-222A/31-3
- With mount from Engine Support Brackets:T40093/3
Engine Support Bridge - Engine Bracket:10-222A/1A
Engine Support Bridge - Adapter:10-222A/34
Engine Support Bridge - Additional Hooks (2 pc.):10-222A/2
Engine Support Bridge - Adapter:10-222A/34

-- Tighten the Engine Support Bridge - Adapters:10-222A/34 on the Engine Support Bridge - Engine Bracket:10-222A/1 with the nuts -arrows-. At the same time, the adapter must engage in the longitudinal member.

-- Engage the Engine Support Bridge - Additional Hooks (2 pc.):10-222A/2 on the engine lifting eyes and the Engine Support Bridge - Spindle:10-222A/11 .

-- Slightly pretension the engine with the spindle, do not lift.

Assembling

Assemble in the reverse order of removal.

-- Remove the fender covers. Refer to OVERVIEW - FENDER .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

Tightening Specifications

Refer to OVERVIEW - LOCK CARRIER .