Fuel Tank Pressure Sensor -G400-, REMOVING AND INSTALLING, AUDI Q7: Removing

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Remove the right rear wheel housing liner. Refer to OVERVIEW - REAR WHEEL HOUSING LINER .

-- Release and disconnect the connector -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vent hose -1- by loosening the hose clamp.

-- Remove the bolts -2 and 3-.

-- Remove the bracket -4- with the Fuel Tank Pressure Sensor -G400- and air filter.

-- Remove the vent hose -2- by loosening the hose clamp.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -3-.

-- Remove the Fuel Tank Pressure Sensor -G400- -4- from the bracket.

Air Filter, Removing: 

-- Remove the vent hose -2- by loosening the hose clamp.

-- Remove the bolt -arrow-.

-- Remove leak detection system air filter -1-.