Guidelines For Clean Working Conditions

Even small pieces of debris can cause faults. When working on the fuel supply and injection system, observe the following guidelines for cleanliness:

• Before loosening, the connection points and surrounding areas must be cleaned thoroughly with engine or brake cleaner, and then the cleaned area must be thoroughly dried.
• Immediately seal off any open lines and connections with clean plugs taken from the Engine Bung Set:VAS6122  , for example.
• Place removed parts on a clean surface and cover them with lint-free cloths.
• Carefully cover or seal opened components if repairs are not performed immediately.
• Only install clean parts: remove the replacement parts from their packaging just before installing them. Do not use any parts that have been kept out of packaging (for example, in a toolbox).
• If the system is open, do not work with compressed air and do not move the vehicle.
• Protect any disconnected connectors from dirt and moisture, and only connect them when they are completely dry.