Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ5, 2021 Audi SQ5, 2020 Audi SQ5, 2019 Audi SQ5, and 2018 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in the installation position and pretension it with the Engine Support Bridge - Spindle:10-222A/11 until the pressure on the engine mount is released. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the front wheel spoiler and drive axle cover. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Disconnect the corresponding connector -arrow- for the electrohydraulic engine mount solenoid valves.

Fig 1: Left/Right Electrohydraulic Engine Mount Solenoid Valve -N144- / -N145- Component Location

Courtesy of AUDI OF AMERICA, LLC

Left Engine Mount:

-- Remove the left front lower longitudinal member. Refer to LOWER LONGITUDINAL MEMBER, REMOVING AND INSTALLING

-- Remove the ribbed belt from the A/C compressor belt pulley. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the A/C compressor from the bracket and tie it up on the left side. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING FROM BRACKET .

Right Engine Mount:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ribbed belt from the generator belt pulley. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove the nut -arrow- and free up the ground wire.

Continuation for Both Sides:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and engine mount -1-. (Shown left).