Engine, Supporting In Installation Position
WARNING: This page is about a different car, the 2022 Audi SQ5, 2021 Audi SQ5, 2020 Audi SQ5, 2019 Audi SQ5, and 2018 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine Support Bridge:10-222A
- Engine Support Bridge - Spindle:10-222A/11
- Engine Support - Supplement Kit:T40093A
Procedure
-- Remove the engine cover and heat shield. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Remove the left and right covers for the fender. Refer to FENDER COVER, REMOVING AND INSTALLING .
-- Position the :10-222A at the left and right on the longitudinal member.
-- Engage the :10-222A/11 at the left and right on the engine lifting eyes.
-- Tension the engine with the spindles slightly until the engine mount is not under a load.
Assembling
Assemble in the reverse order of removal. Note the following:
-- Install the heat shield and engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .