Ribbed Belt, Removing And Installing

WARNING: This page is about a different car, the 2022 Audi SQ5, 2021 Audi SQ5, 2020 Audi SQ5, 2019 Audi SQ5, and 2018 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the left and right bolt -1- and push the coolant pipe on the lock carrier toward the rear.

Fig 1: Coolant Pipes on Lock Carrier - Tightening Specifications:

Courtesy of AUDI OF AMERICA, LLC

Additional procedures. Refer to RIBBED BELT, REMOVING AND INSTALLING .

Tightening Specifications

Refer to OVERVIEW - COOLANT PIPES
Refer to OVERVIEW - NOISE INSULATION .