Center Console with Optional Equipment

Fig 1: Exploded View Of Center Console, Convenience Equipment Level

Courtesy of AUDI OF AMERICA, LLC

Center console securing bracket
- Removing and Installing. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .
Center Console Font Bracket
- Quantity: 2
- Removing and Installing. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .
Nut
- Quantity: 2
- 3.5 Nm
Cap
- Quantity: 2
- Push in the center console
Bolt
- Quantity: 2
- 1.5 Nm
Center Console
- Removing and Installing. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
- Versions with storage net: adding the storage net in the new center console. Refer to STORAGE NET, ADDING IN THE NEW CENTER CONSOLE .
Bolts
- Quantity: 4
- 3 Nm
Liner Mat
Ashtray
- Equipped on some models
- Audi Logo on the ashtray cover is transverse to the direction of travel and ashtray can be used from the driver position
Gearshift Lever/Selector Lever
- Overview. Refer to the appropriate Controls, Housing article - Overview - Gearshift Mechanism .
Selector Lever Transmission Range Position Display Unit -Y26-
- Component Location Overview. Refer to OVERVIEW - CENTER CONSOLE LAMPS .
Center Console Insert Decorative Trim
- Removing and Installing. Refer to CENTER CONSOLE DECORATIVE TRIM, REMOVING AND INSTALLING .
Coin Holder
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Removing and Installing. Refer to COIN HOLDER, REMOVING AND INSTALLING .
- Engage in the rear of the center console and press on it until it engages audibly.
Multimedia System Control Head -E380-
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - INFOTAINMENT SYSTEM .
- Press on until it engages audibly
Center Console Insert
- Removing and Installing. Refer to CENTER CONSOLE INSERT, REMOVING AND INSTALLING .
- Replace damaged or deformed clips
- Engage in the front of the center console and press on it until it engages audibly.
Clamp for Center Console Insert
- Quantity: 6
- Replace damaged or deformed clips
- Place in the insert
Bolt
- Quantity: 4
- Tightening specification : Bolt.
Storage Compartment/Vent
- Removing and Installing. Refer to CENTER CONSOLE REAR STORAGE COMPARTMENT, REMOVING AND INSTALLING .
- Install the cigarette lighter cut out/socket in the new storage compartment. Refer to CIGARETTE LIGHTER/SOCKET CUT OUT IN STORAGE COMPARTMENT, INSTALLING .
- Replace damaged or deformed clips
- Insert and press in all the way into the installation opening
Clamp for Storage Compartment
- Quantity: 6
- Replace damaged or deformed clips
- Place in the storage compartment.
Rear Center Console Trim
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Removing and Installing. Refer to CENTER CONSOLE REAR TRIM, REMOVING AND INSTALLING .
- Press on until it engages audibly
Cover for Clamp
- Quantity: 4
- Replace damaged or deformed clips
- Insert in the cover
Bolt
- Quantity: 4
- Tightening specification : Bolt.
Storage Compartment
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Removing and Installing. Refer to FRONT CENTER CONSOLE STORAGE COMPARTMENT, REMOVING AND INSTALLING .
Bolt
- Quantity: 4
- 1.4 Nm
Nut
- Quantity: 4
- 8 Nm