Front Brake Rotor, Removing And Installing : Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OVERVIEW - FRONT BRAKES .

NOTE:

Ceramic Brake Rotor, determining wear. Refer to CERAMIC BRAKE ROTOR, DETERMINING WEAR .

Always replace brake rotors on both sides of the axle.

When installing brake rotors, pay attention to the arrow showing the direction of travel and to the left and right installed location.

-- Thoroughly clean the brake rotor and hub contact surfaces.

-- Place the brake rotor on the hub.

NOTE: Do not tilt the brake rotor when mounting it on the wheel hub.

-- Tighten the bolt -1-.

Fig 1: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE: Ignore the -arrows-.

-- Install the brake caliper. Refer to Installing .

WARNING:

Make sure the brakes are working correctly before driving the vehicle for the first time.

After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.

Check brake fluid level, and fill if necessary.